| Official Luthiers Forum! http://www-.luthiersforum.com/forum/ |
|
| Unslotted oversized bridge pins? http://www-.luthiersforum.com/forum/viewtopic.php?f=10137&t=48355 |
Page 1 of 1 |
| Author: | Colin North [ Sun Oct 02, 2016 1:45 pm ] |
| Post subject: | Unslotted oversized bridge pins? |
Looking for unslotted oversized bridge pins (preferably rosewood), dizzy from search the net. Anyone know a supplier? |
|
| Author: | Freeman [ Sun Oct 02, 2016 6:38 pm ] |
| Post subject: | Re: Unslotted oversized bridge pins? |
Bob Colosi comes to mind altho I haven't actually checked his site. |
|
| Author: | david farmer [ Sun Oct 02, 2016 7:54 pm ] |
| Post subject: | Re: Unslotted oversized bridge pins? |
How big under the collar? |
|
| Author: | Colin North [ Mon Oct 03, 2016 2:21 am ] |
| Post subject: | Re: Unslotted oversized bridge pins? |
Current plastic (Martin) ones average out at 5.6 mm, plan was to taper (3 deg) the pinhole, slot the bridge, and my trigonometry is useless.... 0.235" (5.97 mm) are the oversized, slotted waverleys from SM, so figured that would be about right. |
|
| Author: | david farmer [ Mon Oct 03, 2016 7:16 am ] |
| Post subject: | Re: Unslotted oversized bridge pins? |
Sorry Colin, I have a bunch of .220" 3 and 5 degree pins but none that big. I went through the same search. I sent a note to Stew mac at the time that un-fluted, over-sized pins were a real need but apparently they still disagree. A lot of plate wear could be stopped if they were available.  Guess we should have bought Gurian. 
|
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|